More wiring. Test cut panel. Mounted transponder
29 Mar 2017 15 hours

For the last few days I’ve been working on various wiring tasks. I also started to install the avionics. After design what I wanted the panel to look like, I test cut it using acrylic plastic. This was a great way to feel out switch placement and clearances.

Wire runs

wired up the control sticks

test cut the panel using acrylic

test fit some of the avionics to verify clearances and positioning

wired up the flap motor

wire runs from the aft fuselage

wires crossing the wing bulkhead

Engineered a solution to mounting the remote transponder

Design pdevty